Active
E-400 Electric Applicators
Brand
Category
Applicators
For high-speed bead applications, E-400 series electric guns provide optimum performance and superior accuracy. With cycle rates below 6 milliseconds, E-400 guns accommodate a wide range of viscosities and provide superior repeatability for greater bead pattern control and consistency.
Specifications
Other
Cycle Rateup to 300 Hz | Cycles are per second. This depends on the
adhesive.
Cycle Time4-6 ms | Shortest total time the valve can fully open
and close. This time is adhesive dependant.
Closing Time2-3 ms | Time at which it takes the valve to
de-energize and close fully. This time is
adhesive dependent.
Opening Time2-3 ms | Time at which it takes the valve to fully open.
This time is adhesive dependent.
Heater WattageMarked on identification plate
Applicator
Mounting12mm or ½″ hex/round stock
Operating
Temperatureup to 190° C (375° F) | Operating over 190° C may result in
premature failure.
Coil Electrical Service380 VDC, 2A Peak, 0.4A Hold | Operating voltage of coil
Maximum
Working Pressure82.7 bar (1200 psi) | Maximum pressure module can actuate
Heater Electrical Service240VAC 50/60 Hz | Operating voltage of heater
Maximum
Hydraulic Pressureup to 103 bar (1500 psi) | Maximum rated pressure
Reccommended
Viscosity Range800-1200 mPas | Adhesive viscosity outside the recommended
range may result in splashing, slower cycle
times or an increase in stringing